To Set The Rip Fence Pointer - skilsaw SPT99T Consignes D'utilisation/De Sécurité

Table des Matières

Les langues disponibles

5 . Right side, position 2 (further from blade),

see Fig. 30.

NOTE: The right side position 2 for the fence

permits cuts of 4 to 25 inches on the right side of

the blade . The bottom scale shows this dimen-

sion. In this location, the flip-over fence should

be on the left of the main fence when in the ma-

terial support position (closest to the blade) .

a . Unlatch the fence clamps and remove the

fence .

b . Loosen the right side position 2 bolts on

the front and back rails so that they can

slide freely, approximately 1/2 to 1 turn.

c . Using the fence alignment holes in the

blade wrench, place the wrench over the

right side position 1 bolt on the front rail

(already fixed in place by step 4 above)

with the second hole roughly aligned with

the right side position 2 bolt .

d . Move the right side position 2 bolt until the

blade wrench slides over the bolt head .

e . Tighten the right side position 2 bolt .

f . Perform steps c through e for the back rail

bolt .

6. Left side, see Fig. 30.

NOTE: The left side position for the fence permits

cutting of 0 to 12 inches on the left side of the blade .

The scale does not show this dimension . In this lo-

cation, the flip-over fence should be on the right of

the main fence when in the material support or aux-

iliary fence position (closest to the blade) .

a . Loosen the left side bolts on the front and

back rails so that they can slide freely, ap-

proximately 1/2 to 1 turn. Move the bolts

so they are approximately 3 .5 inches from

the left end of the rails .

b . Place the fence on the left-side bolts but do

not secure the latches on the front or back rail .

c . Move rails so that the fence touches at

least one tooth on the blade . Lock the rails

in place using the rail lock paddle . If an-

ti-kickback pawls are installed, you will

need to raise the right side in order to align

the fence with the blade .

d . Slide the fence with the front and back

screws towards the blade until the fence

touches the blade teeth at the front and

back of the blade .

e . Tighten the front bolt . Verify that the fence

is still in contact with the front and back

teeth of the blade .

Adjustments

f . Tighten the back bolt . Verify that the fence

is still in contact with the front and back

teeth of the blade .

g . Latch the fence clamps onto the rails and

ensure that the fence is still in contact with

the front and back teeth of the blade .