Positioning The Riving Knife; Assembly - skilsaw SPT99T Consignes D'utilisation/De Sécurité

ATTACHING THE SMART GUARD SYSTEM
To prevent personal injury,
WARNING
always dis con nect the plug
from the power source before attaching or
removing the Smart Guard System.

POSITIONING THE RIVING KNIFE

1. Remove the table insert using finger hole.
2 . Raise the blade as high as it will go and set it
perpendicular to table (0° on bevel scale) (Fig . 5) .
3 . Rotate the riving knife release lever clockwise,
so that it points upward (Fig . 5) .
4 . Pull the riving knife toward the release lever to
disengage it from the pins .
5 . Slide the riving knife up to its highest position, so
that it is directly over the center of the blade (Fig . 6) .
6 . Align the holes in riving knife with the pins and
lock the release lever by rotating it counterclock-
wise. Push/pull on the riving knife to verify that it
is locked in place (Fig . 6) .
7 . Replace the table insert .

Assembly

-17-
FIG. 5
Riving Knife
Release Lever
FIG. 6
Pins