skilsaw SPT99T Consignes D'utilisation/De Sécurité page 34

MATERIAL SUPPORT / AUXILIARY FENCE
When the fence is beyond the table-top, ensure that
the material support is secured in the lowest posi-
tion in both the front and the back slots
(Fig . 45a) . When the fence is over the table, ensure
FIG. 45a
USING THE RIP FENCE POINTER
The rip fence pointer shows the distance from the
blade to rip fence .
Right position 1.
The top scale indicates the position of the fence
relative to the right side of the blade for the inner
position . In this position, the fence can be used
from 0 to 20 .5 inches (Fig . 46) .
FIG. 46
Left
Basic Table Saw Operation
Right 1 Right 2
that the material support is in the stowed position . If
an auxiliary fence is required, place the material
support in the upper position on both the front and
back slots (Fig . 45b) . To secure fence setting, lower
the lock handle .
FIG. 45b
Right position 2.
The bottom scale indicates the position of the
fence relative to the right side of the blade for the
outer position . In this position, the fence can be
used from 4 to 25 inches (Fig . 46) .
Left position.
The scale has no relevance for this position . The
maximum capacity on the left side of the blade is
12 inches (Fig . 46) .
-34-