skilsaw SPT99T Consignes D'utilisation/De Sécurité page 14

14. TABLE
Provides large working surface to support
the workpiece .
15 MITER GAUGE
Head can be locked in the desired position
for crosscutting or mitering by tightening the
lock knob . ALWAYS SECURELY LOCK IT
WHEN IN USE .
16. ANTI-KICKBACK DEVICE STORAGE
Storage location for the anti-kickback de-
vice when not in use, or when transporting
or storing the table saw .
17. RIP FENCE STORAGE
Storage location for the rip fence when
transporting or storing the table saw .
18. MITER GAUGE STORAGE
Storage location for the miter gauge when
not in use, or when transporting or storing
the table saw .
FIG. 2
14
17
Voltage Rating
Tool Current Rating
Blade Diameter
Arbor Size
No Load Speed
Bevel Capacity
Depth of Cut (in .) at 90°
Depth of Cut (in .) at 45°
Rip Capacity on the Right Side of the Blade
Rip Capacity on the Left Side of the Blade
Cord Length
Getting To Know Your Table Saw
15
18
SPECIFICATION
19. HEX WRENCH & STORAGE
Hex wrench for adjusting the riving knife/
splitter and various hex heads on the saw .
20. WRENCH & STORAGE
Wrench for the removal and installation of
saw blades .
21. DUST PORT/VACUUM HOOK-UP
Removable to clear any large pieces of
wood trapped inside . Always check to en-
sure dust port is securely fastened to the
table saw before use. Attach a 2-1/4" vac-
uum hose into the dust port for convenient
sawdust removal .
22. SMART GUARD SYSTEM STORAGE
Storage location for the Smart Guard Sys-
tem when not in use, or when transporting
or storing the table saw .
19 20
21
120V AC 60Hz
15 A
8-1/4ʺ
5/8ʺ (15 .88 mm)
5300 /min
-1° to 46 .5°Bevel, with stops at 0° and 45°
2-5/8 inches (68 mm minimum)
1-7/8 inches (48 mm)
25 inches
12 inches
6ft (1 .8m)
-14-
16
22