Installation; Unpacking; Installation Of The System - Millipore Milli-Q Guide De L'utilisateur

INSTALLATION

Milli-Q
Ac Gr Bio Syn A10

Unpacking

The different components supplied with the system are shown in figure 2 and are listed below.
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(J)
(K)
(L)
Items ordered separately
(M)
(N)
(O)
Checked by
Verified by

Installation of the system

Note: The feedwater supply valve, pressure regulator with gauge are not supplied with the Milli-Q and must
be ordered separately. Contact Millipore Technical Service for more information.
10
Milli-Q water purification system
Electrical power cord
Folder with documents to insert
Tubing 8 mm OD, 5 meters length for:
- inlet water connection
- reject stream for ultrafiltration module
Tubing (6 mm OD), 2.5 meters length for A10 waste stream
Tubing used when UF module is sanitised and cartridges are purged
Fitting 1/4" MNPT - hose barb (MNPT = male national pipe thread)
Fitting 1/2" FNPT - 8 mm OD tubing with screen filter inside
Fitting 1/4" MNPT - 8 mm tubing
Teflon tape
TM
Plastic bag containing elbow fittings
Six sided key used to loosen / tighten point of use arm
Q-Gard purification pack
Quantum ultrapure cartridge
MILLIPAK 40 final filter (0.22 µm) for point of use gun
Name
Name
The system can either be placed on a bench or wall mounted.
If the system is to be wall mounted, then it is necessary to first verify that the wall can support
the weight of the system.
Contact Millipore Technical Service for further instructions on wall mounting the system.
Some versions of the Milli-Q systems require a drain nearby. When a reservoir is used as a
feedwater supply, locate the system and reservoir close together whenever possible.
Figure 5 shows the different connections to be made to the system.
Signature
Signature
Present?
Yes No
Date
Date