Use Of The Keypad - Millipore Milli-Q Guide De L'utilisateur

OPERATING THE MILLI-Q SYSTEM

Use of the Keypad

The keypad allows the user to activate the different operating modes or to review information about system
performance.
KEYPAD
STANDBY and PRE-OPERATE
OPERATE MEASURE CLEANING MENU
STAND/BY
Measure
OPERATE MEASURE CLEANING MENU
STAND/BY
Cleaning
OPERATE MEASURE CLEANING MENU
STAND/BY
Menu function
Programming a dispensing time period
OPERATE MEASURE CLEANING MENU
STAND/BY
OPERATE MEASURE CLEANING MENU
STAND/BY
OPERATE MEASURE CLEANING MENU
STAND/BY
Note: Moving the point of use trigger forward will initiate the COUNTER and start to dispense water. The
system will dispense water from the point of use gun for the amount of time that the COUNTER is set
to. When the dispensing time is finished (COUNT = 0), the system will automatically go to STANDBY
mode. Move the trigger back to the vertical position to go to PRE OPERATE mode.
ACTION
Press the OPERATE/STANDBY keypad
button for at least 2 seconds to switch
between these two operating modes.
: PRE-OPERATE
In PRODUCT or PRE-OPERATE mode
Press MEASURE to display temperature
and last TOC value.
The CLEANING function is described in the ROUTINE MAINTENANCE chap-
ter. This is for cleaning and sanitising the ultrafiltration module.
In PRE-OPERATE mode only,
Press MENU for at least 2 seconds.
↓
Select or change the counter time by
pressing the arrow keys
Press OPERATE/STANDBY for at least
2 seconds to accept the COUNTER
time.
DISPLAY
: STANDBY
S T A N D B Y
P R E O P E R A T E
T O C
T E M P :
T O C :
P R O D . T I M E
C O U N T E R :
P R O D . T I M E
or
C O U N T E R :
P R E O P E R A T E
Milli-Q
Ac Gr Bio Syn A10
2 2 . 6 ° C
3 p p b
S E T U P
0 m n
S E T U P
1 3 m n
17