Napoleon PATIOFLAME Mode D'emploi page 7

Installation
WARNING!
a combustible surface, nor can it be located below a combustible overhang.
The log set and the burner assembly are shipped together.
• Remove the gas log set and burner assembly and check for damage. DO NOT install damaged
components. The logs are fragile use care when handling.
• Place the appliance on a level/secure surface in desired location. This location must be adjacent to the
gas supply line or cylinder.
NOTE: Minimum clearances to combustible construction must be maintained, see "SPECIFICATIONS"
section.
WARNING!
installed and connected to the gas supply in order to safely turn off the burner.
THE ON/OFF GAS VALVE IS USED TO TURN THE BURNER ON AND OFF.
Gas Hook-Up Instructions
Natural Gas Hook-Up
The gas appliance is designed to operate at an inlet pressure of 7 inches water column. The piping up to
the appliance is the responsibility of the installer. Connect the inlet valve to rigid pipe, copper tube or an
approved flexible metal connector, which complies with Z21.4/CSA 6.10. If using a gas hose (not supplied)
connect the flared end of the hose to the connector on the end of the inlet valve. Tighten using two
wrenches. (Do not use thread sealer/pipe dope.) Leak test all joints prior to using the appliance. Piping
and valves upstream of the quick disconnect are not supplied. The gas supply pipe must be sufficiently
sized to supply the BTU/h specified on the rating plate, based on the length of the piping run. The quick
disconnect must not be installed in an upward direction and a readily accessible manual shut-off valve
must be installed upstream of, and as close to, the quick disconnect as is feasible.
Purge the gas supply line of any trapped air prior to the first firing of the unit.
WARNING!
• The installation must be performed by a licensed gas fitter, and all connections must be leak tested
before operating the appliance.
• Ensure all hose connections are tightened using two wrenches. Do not use Teflon tape or pipe dope
on any hose connection.
• Ensure the hose does not contact any high temperature surfaces or it may melt and leak causing a
fire.
• Locate the hose out of pathways where people may trip over it or in areas where the hose may be
subject to accidental damage.
• Leak test all the connections using a soap and water solution as indicated in the diagrams.
DO NOT USE AN OPEN FLAME.
Manual Gas
Valve (on/off)
N415-0359 JUN 12.18
When the appliance is being used with the optional tripod, it must not be situated on
You must have clear and easy access to the on/off valve AFTER the appliance is
Burner Assembly
7
EN
www.napoleongrills.com