Napoleon PATIOFLAME Mode D'emploi page 17

NORMAL
Cleaning The Outer Appliance Surface: Do not use abrasive cleaners or steel wool on any painted, or
stainless steel parts of your Napoleon Appliance. Doing so will scratch the finish. Exterior surfaces should
be cleaned with warm soapy water. To clean stainless surfaces, use a stainless steel or a non-abrasive
cleaner. Always wipe in the direction of the grain. Over time, stainless steel parts discolor when heated,
usually to a golden or brown hue. This discoloration is normal and does not affect the performance of the
appliance
WARNING!
other flammable vapors and liquids. Do not obstruct the flow of combustion and ventilation air. Keep
the ventilation opening of the cylinder enclosure free and clear of debris.
High Elevation Installation
This listed gas appliance is tested and approved for elevations from 0 to 4500 feet in Canada and the U.S.
When installing this appliance at an elevation above 4500 feet (in the U.S.), it may be necessary to
decrease the input rating by changing the existing burner orifice to a smaller size. Input should be reduced
four percent (4%) for each 1,000 feet beyond the 4,500 feet above sea level, unless the heating value of
the gas has been reduced, in which case this general rule will not apply. To identify the proper orifice size,
check with the local gas utility.
When installing this unit at an elevation above 4,500 feet (in Canada), check with local authorities.
Consult your local gas utility for assistance in determining the proper orifice for your location.
N415-0359 JUN 12.18
The appliance area must be clear and free from combustible materials, gasoline and
ABNORMAL
www.napoleongrills.com
17
EN