INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.
THESE INSTRUCTIONS ARE TO BE USED IN CONJUNCTION WITH THOSE FOR THE GPV AND (C)HDX40.
THIS INFORMATION SUPERSEDES THAT IN THE (C)HDX40 INSTALLATION INSTRUCTIONS.
CONSUMER: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Included in this kit:
W010-1777
Assembly, firestop spacer
W175-0309
Connector, reducer 5/8" to 4/7"
W500-0420
Plate, electrical box cover
W660-0078
Double pole switch
W750-0127
Wire, 14" jumper
W750-0197
Wire harness, unit
W750-0211
Wire, thermostat
The (C)HDX40 uses 5" and 8" fl exible venting. When
installing the GPV for use with the (C)HDX40, the 4"/7"
reducer (W175-0309) is required. The reducer must
be properly secured and sealed to unit using high
temperature sealant W573-0007 Mill Pac (not supplied)
before continuing with vent installation.
TERMINAL INSTALLATION
REFER TO GPV INSTALLATION INSTRUCTIONS
WIRING DIAGRAM AND INSTALLATION
REFER TO GPV INSTALLATION INSTRUCTIONS SECTIONS "DEXEN 6003-3V COMPLETE WITH GPV
POWER VENT TERMINAL"
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212 • fax (705)722-6031 •
PVA40 POWER VENT
INSTALLATION INSTRUCTIONS
ADAPTOR KIT
www.napoleonfireplaces.com
1