PEERLESS PARAMOUNT PT640 Installation Et Assemblage page 8

Mounting and Removing Flat Panel Display
WARNING
• Always use an assistant or mechanical lifting equipment
to safely lift and position the fl at panel display.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing display from
the bottom.
Tension Adjustment of Ratchet Handle:
3
tension in tilt brackets (BB & CC) by rotating
ratchet handle. NOTE: If obstruction prevents
ratchet handle from rotating, pull handle out while
turning will allow handle to reposition without
tightening. Release and turn handle to tighten or
loosen.
Mounting Display: Ratchet handle must be in the
up or down position or interference will occur while
hooking tilt brackets to wall plate (AA). Slowly
hook tilt brackets (BB & CC) onto wall plate (AA)
and swing display down as shown in fi g. 3.1. Tilt
bracket hooks must fully engage wall plate as
shown in detail 1. Using phillips screw driver, turn
safety screws on tilt brackets (BB & CC) clockwise
till screw tip securely contacts wall plate as shown
in cross section.
Display Adjustment: Display can be adjusted
horizontally by loosening safety screws on tilt
brackets (BB & CC) three full turns with phillips
screw driver. Adjust display as shown in fi g. 3.2.
Tighten safety screws on tilt brackets till screw
tip securely contacts wall plate as shown in cross
section.
Removing Display: To remove display from
mount, loosen safety screws, swing display away
from mount, and lift display off of mount.
Adjusting the Tilt Angle of the Flat Panel
Display
For preset tilt angles use
4
custom tilt angle use ratchet handle.
INCRELOK™: The display can be locked into a
pre-set tilt position of -5°, 0°, 5°,
locator hole to fi nd tilt position hole and tilt display
to align holes. Tighten IncreLok™ tilt locking
screws on both tilt brackets to lock tilt as shown in
detail 2.
Ratchet Handle: Loosen ratchet handle (refer
to step 3 for tension adjustment of handle).
or pull from top or bottom of display to adjust tilt
as shown in fi g. 4.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.
Adjust
Increlok™ and for
10° or 15°. Use
Push
8 of 34
AA
DETAIL 1
AA
SAFETY
SCREW
CROSS SECTION
IncreLok™ TILT
LOCKING SCREW
TILT
POSITION
HOLES
DETAIL 2
ISSUED: 10-31-07 SHEET #: 202-9242-6 04-09-11
All other brand and product names are trademarks or registered trademarks of their respective owners.
BB &
CC
RATCHET
HANDLE
BB &
CC
LOCATOR
HOLE
RATCHET
HANDLE
fi g 4.1
© 2011, Peerless Industries, Inc. All rights reserved.
Peerless Industries, Inc.
2300 White Oak Circle
www.peerlessmounts.com
fi g 3.1
fi g 3.2
Aurora, Il 60502