PEERLESS PARAMOUNT PT640 Installation Et Assemblage page 6

Attaching Tilt Brackets to Display using Baffl ed Fastener Pack
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening
can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to
become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display. Place
2
display face side down. Refer to display manufacturers instructions or customer service, for removing any knobs,
base, cover or screw(s) on the back of the display to prepare mounting. These need to be removed to allow the tilt
brackets to be attached. Select the small, medium, large or extra large screws from the baffl ed fastener pack then
attach tilt brackets to display following fi gure 2.1 or 2.2.
NOTE: Top and bottom mounting holes on display must be used for attaching brackets.
NOTE: Be sure to attach tilt brackets with handles facing outward as shown below. Verify that all holes are properly
aligned, and then tighten screws using a phillips screwdriver.
HANDLES FACE
OUT
BB
NOTE: For fl at back displays proceed to step 2-1. For bump-out or recessed back display skip to step 2-2.
WARNING
CENTER BRACKETS VERTICALLY ON BACK OF DISPLAY
Note: "X" dimensions should be equal.
6 of 34
ISSUED: 10-31-07 SHEET #: 202-9242-6 04-09-11
X
CC
X