PEERLESS PARAMOUNT PT640 Installation Et Assemblage page 7

Supports muraux inclinables universels pour écrans plats de 23 à 46 po* (58 - 117 cm)
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

For Flat Back Display
Begin with the shortest length screw, hand thread through washer and tilt bracket into display as shown below.
2-1
Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over tighten. If
screw cannot make three full turns into the display, select a longer length screw from the baffl ed fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with longer length screw, hand thread through washer, tilt bracket and spacer in that order into display as
2-2
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
DISPLAY
SPACER
7 of 34
fi g. 2.1
WASHER
SCREW
TILT BRACKET
(BB or CC)
fi g. 2.2
WASHER
SCREW
TILT BRACKET
(BB or CC)
ISSUED: 10-31-07 SHEET #: 202-9242-6 04-09-11

Publicité

Chapitres

Table des Matières
loading

Table des Matières