Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EMC information
Warning
• Use of this appliance adjacent to or stacked with other device should be avoided because it could result
in improper operation. If such use is necessary, this appliance and the other device should be observed to
verify that they are operating normally. If the appliance does not light on or is flickering, it means that the
appliance is not operating normally.
• Do not change any cable without authorization of the manufacturer. Use of cables other than those speci-
fied or provided by the manufacturer of this appliance could result in increased electromagnetic emissions
or decreased electromagnetic immunity of this appliance and result in improper operation.
• Portable RF communications equipment (including peripherals such as antenna cables and external
antennas) should be used no closer than 30 cm to any part of this appliance, including power cable. Oth-
erwise, degradation of the performance of this equipment could result.
• If the appliance does not light on or is flickering due to the electromagnetic disturbances, do not use it
and try to place the appliance in other location.
• For maintaining the basic safety and essential performance with regard to electromagnetic disturbances
for the expected service life, please take precaution if the use location is near (e.g. less than 1,5 km from)
from AM, FM or TV broadcast antennas.
Repairs
Important
• Do not open the device. Do not attempt to repair the device yourself. This can result in serious injury. Fail-
ure to comply with this instruction will void the warranty.
• For repairs, please contact Customer Services or an authorised retailer.
• Do not use the device if it is damaged. If the device is not working, try to solve the problem using the
information in chapter "What if there are problems?". If you are unable to solve the problem, contact Cus-
tomer Services or an authorised retailer.
5. Device description
Overview
1. Fluorescent screen
2. Rear of the housing
3. Stand
4. ON/OFF button
5. Mains part connection
6. Storage slot for stand
7. Holder for using the
stand
6. Initial use
Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact Customer Services or your supplier.
Setting up the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 10 cm and
30 cm between the user and the device. The lamp is most effective at this distance.
Mains connection
• To prevent possible damage to the device, the daylight therapy lamp must only be used with the mains
part described here.
• Insert the mains part into the connection provided for this purpose on the rear of the daylight therapy
lamp. The mains part must only be connected to the mains voltage that is specified on the type plate.
• Plug the mains part into a suitable socket.
• After using the daylight therapy lamp, unplug the mains part from the mains socket first and then discon-
nect it from the daylight therapy lamp.
1
13
4
2
6
3
5
7
Publicité
Chapitres
Table des Matières
