Mounting And Demounting Motorcycle Tires; Maintenance - Snap-On EEWH306A Instructions

®
6.0 MOUNTING AND DEMOUNTING MOTORCYCLE
TIRES
To mount and demount motorcycle tires it is necessary
to utilize the optional four motorcycle adaptors (part
number EAA0304G23A).
The bead-breaking, mounting and demounting technique
is the same as per the car, tubeless or tube-type tires.
NOTICE!
MOTORCYCLE RIMS MUST ALWAYS BE CLAMPED
FROM THE OUTSIDE. AIR PRESSURE MUST NOT
EXCEED 110 PSI (8 BAR) WHEN CLAMPING
MOTORCYCLE RIMS.

7.0 MAINTENANCE

BEFORE STARTING ANY MAINTENANCE OPERATION
ENSURE THAT THE MACHINE IS DISCONNECTED
FROM THE AIR AND ELECTRIC SUPPLY.
A. Periodically clean the vertical hexagonal rod with
nonflammable liquid detergent.
After this immediately lubricate with a light lubricating oil
(Fig.7.0-1).
Fig.7.0-1
B. Periodically clean all moving metal parts and lubricate
with oil.
Page 22
EEWH306A Tire Changer Operation Manual
C. Weekly clean the teeth of the clamps (1) with a wire
brush, check the nylon clamping jaw insert and (2) replace
if worn (Fig.7.0-2).
Fig.7.0-2
D. Inspect and replace as necessary the plastic mount/
demount head insert. The insert is held in place by a
small roll pin. Drive the pin out with a punch, replace
after new insert is installed.
E. Lubricate piston rods of turntable air cylinders with oil
as needed.
F. Periodically wash all plastic parts with cold water and
soap or window cleaner.
G. Check the bead breaker pads. Replace if worn.
H. Discharge water from air filter every day.!! (Do this
by turning the knob "B" clockwise and upward. Water
will automatically be discharged.) (see 'B' at Fig.7.0-3).
538
642
Operation Manual