Optional Accessories; General Cautions; Installation; Anchoring - Snap-On EEWH306A Instructions

EEWH306A Tire Changer Operation Manual
1.5

OPTIONAL ACCESSORIES

EAA0304G23A - Motorcycle Adapter- 4 required
(Fig.1.5-1)
Figure 1.5-1
EAA0304G24A - 8" Wheel Adapter- 4 required
(Fig.1.5-2)
Figure 1.5-2
EAA0247G70A - Bead Holding Clamp (Fig.1.5-3)
Figure 1.5-3
Operation Manual
1.6

GENERAL CAUTIONS

A. DURING THE USE AND MAINTENANCE OF THE
MACHINE IT IS MANDATORY TO COMPLY WITH ALL
L AWS AND REGULATIONS
PREVENTION.
B. THE ELECTRICAL POWER SOURCE MUST HAVE A
GROUND CABLE AND THE GROUND CABLE OF THE
MACHINE MUST BE CONNECTED TO THE GROUND
CABLE OF THE POWER SOURCE.
C. BEFORE ANY MAINTENANCE OR REPAIRS ARE
ACCOMPLISHED
DISCONNECTED FROM THE AIR AND ELECTRICAL
SUPPLY.
D. NEVER WEAR TIES, CHAINS OR OTHER LOOSE
ARTICLES WHEN USING, MAINTAINING OR
353
REPAIRING THE MACHINE. LONG HAIR IS ALSO
DANGEROUS AND SHOULD BE KEPT UNDER A HAT.
THE USER MUST WEAR PROPER SAFETY ATTIRE -
GLOVES, SAFETY SHOES AND GLASSES.
2.0

INSTALLATION

Your new Snap-on EEWH306A Tire Changer requires a
simple installation procedure requiring only a few
moments. Follow these instructions carefully to insure
proper and safe operation.
The Tire Changer is delivered mounted to a wooden skid.
Remove tire changer from its mounts carefully, taking care
to avoid any back strain.
352
Place Changer where proper operation will be
unobstructed to all sides. Install the machine in a covered
and dry place.

2.0.1 Anchoring

Once placed in the desired location the tire changer must
be bolted to the floor using only the rear two mounting
holes. Mounting anchors are provided with machines.
Tire Changer should be anchored to concrete
floor for increased safety.
315a
FOR ACCIDENT
THE MACHINE MUST
®
BE
Page 13