Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
and lower half of the support frame together again and insert the height adjustment
slots.
4. Position upper half of support frame so that the support frame opening is on
the short side of the hood.
5. Secure the upper half of support frame to joists and cross framing with four screws
provided. Make sure screws are driven into center of joists and framing for maxi-
mum strength.
6. Adjust the overall height of the support frame. Loosen and re-tighten the screws
in the height adjustment slots as necessary. Note that the hood height is 10-7/8"
and that the bottom of the hood must be 24" min. and 30" max. above the cooktop.
CONNECT DECORATIVE FLUE
1. Secure the upper decorative flue section
to the upper support frame.
2. Temporarily hang the lower decorative flue
section from the support frame.
INSTALL DUCT CONNECTOR
1. Secure the duct connector to the top of the
hood imaking it get into it until it is restrained.
MOUNT HOOD TO SUPPORT
FRAME
1. Insert four (4) bolts through the top of the
hood - from the inside.
2. Use four (4) nuts to secure hood to support
frame as shown.
UPPER
DECORATIVE
FLUE
SECTION
LOWER
DECORATIVE
FLUE
SECTION
DUCT
CONNECTOR
- 4 -
NUT
BOLT
Publicité
Table des Matières
