Revell Control ORBIX Mode D'emploi page 10

• T he combination of different
types of batteries as well as
new and used batteries must
be avoided.
• O nly recommended batteries
or those of an equivalent type
may be used.
• B atteries must be inserted
according to the correct
polarity (+ and -).
• D epleted batteries must be
removed from the remote
control.
• T he connection terminals may
not be short-circuited.
• R emove the batteries from the
remote control if they are not
to be used for an extended
period of time.
Charging unit safety
instructions:
• N on-rechargeable batteries
may not be charged.
• T his charging unit is not
suitable for people (including
children) with physical or
mental limitations, or those
with insufficient knowledge
and experience of charging
units, unless under supervision
or following proper directions
from a parent or legal guardian.
• C hildren must be supervised –
the charging unit is not a toy!
• T he charging unit for the LiPo
battery is specially designed
for the charging of the model
battery. The charging unit may
only be used to charge the
model battery, not other
batteries.
18
The model is equipped with
a rechargeable lithium
polymer battery. Please
observe the following safety
instructions:
• N ever throw LiPo batteries into
a fire or store them in a hot
location.
• O nly use the supplied charger
to charge the battery. The use
of a different charger may lead
to the permanent damage of
the battery
and neighbouring parts, as
well as physical injury!
• N ever use a charger for NiCd/
NiMH batteries!
• A lways ensure that the
charging process takes place
on a fireproof surface in a
fire-resistant environment.
• D o not leave the battery
unsupervised during the
charging process.
• N ever disassemble or alter the
battery contacts. Do not
damage or puncture the
battery cells. There is a risk of
explosion!
• T he LiPo battery must be kept
out of reach of children.
• W hen disposing of batteries,
they must be discharged or
their capacity must be fully
depleted. Cover exposed
terminals with adhesive tape
in order to prevent short-
circuiting!
Maintenance and care:
• P lease only use a clean, damp
cloth to wipe off the model.
• P rotect the model and
batteries from direct sunlight
and/or direct heat.
• N ever allow the remote
control and charging unit to
come into contact with water,
because the electronics will be
damaged as a result.
Technical changes and
differences in color reserved!
Required batteries for the
model:
Power supply:
Rated output:
1 x DC 3,7 V / 0,4 Wh
rechargeable
LiPo battery (included)
Capacity: 110 mAh
1 modEl
1A Rotors
1B Charging connection
2 sparE rotor sEt
2A Control for thrust and rotation
2B Control for forwards/
backwards and banking
2C ON/OFF switch
2D Power LED
2E Left/right flip buttons; press
and hold both buttons:
headless mode
Battery requirement for the
remote control:
Power supply:
DC 3 V
Batteries:
2 x 1.5 V "AAA"
(not included)
USB charger:
Power supply: DC 5V
via USB port, 500 mA
or higher
Rated output: 4,2 V /
500 mAh max.
1C ON/OFF switch
1D Status LED
2F Battery compartment cover
2G Battery compartment
securing screw
19