6.3
LEd / REmOTE RECEIvER / ThERmOSTAT REPLACEmENT
TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED
SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
1. To replace LED lights in the ember bed, flame and/or decorative lights, disconnect the quick connect plug
from the control board and replace with a new one.
2. To replace the remote receiver and thermostat wires, disconnect the quick connect plug from the control
board and replace with a new one.
6.4
FuSE REPLACEmENT
1. Remove the plastic cover from the fuse. pull the fuse (2Amp) out from the control board. Install the re-
placement fuse and plastic cover.
WARNING
!
19
EN
W415-2166 / A / 06.29.16