Operation; Safe Operating Practices; Control Panel; Controls - HUSTLER X-ONE Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 229

Safe Operating Practices

Refer to the Safety Precautions section of this manual for
operational and personal safety information.

Control Panel

E
C
D
H
I
A. Fuel gauge
B. Hour meter
C. Throttle
D. Choke
E. Deck clutch switch
Figure 3-1
A.
Fuel tank gauge (Figure 3-1 & Figure 3-2) — this gauge
shows the fuel level for each fuel tank. The right gauge
indicates the fuel in the right tank and the left gauge
indicates the fuel level in the left fuel tank.
B.
Electronic hour meter (Figure 3-1 & Figure 3-2) — regis-
ters 1/10 hour increments up to 9,999.9 total hours. It
is connected to the ignition switch. It records the
accumulative time while the ignition key is switched to
the "RUN" position.
C.
Throttle control (Figure 3-1) — a cable is linked to the
engine throttle for controlling engine speed. Move the
lever forward to increase engine rpm, move the lever
rearward to decrease engine rpm.
D.
Choke control (Figure 3-1) — a cable is linked to manu-
ally operate the engine choke. When the lever is in the
down position, the choke is in the "OFF" (run) position.
When the knob is pulled up, the choke is in the "ON"
(start) position. Do not operate the machine in the
"ON" (start) position.
E.
Deck clutch switch (Figure 3-1) — this switch engages
the deck. Pull the switch up to engage and push
switch down to disengage the clutch.
For additional clutch information refer to the Mower
Deck Operation section of this manual.
606528CE

OPERATION

B
F
A
G
F. Oil pressure light
G. Ignition switch
H. 10 amp fuse
I. 20 amp fuse
A
A. Fuel gauge – left tank
B. Fuel gauge – right tank
F.
Oil pressure light (Figure 3-1) — this light comes on
when the ignition switch is placed in the "RUN" posi-
tion and stays lit until the engine is running and a safe
oil pressure is developed. If the light comes on during
operation, shut the engine off immediately and locate
and correct the problem.
G. Ignition switch (Figure 3-1) — a three position switch:
"OFF", "RUN", and "START". With key inserted, rotate it
clockwise to the "START" position; release the key
when the engine starts, and the switch will automati-
cally return to the "RUN" position.
H. 10 amp fuse (Figure 3-1) — Ignition system & Safety
system - 10 amp, blade-type.
I.
20 amp fuse (Figure 3-1) — Controller - 20 amp, blade-
type.

Controls

A.
Steering control levers (Figure 3-3 & Figure 3-4) —
these levers control the mower's speed, direction,
stopping, and park brake.
The parking brake may not hold the mower if
parked on a slope. Block or chock the machine
when parked on a slope.
B.
Deck lift pedal (Figure 3-5) — the deck lift pedal is
used to raise or lower the deck. Push on the pedal to
raise the deck and then place the adjusting pin into the
desired cutting height hole. Release the pedal.
3-1
C
B
C. Hour meter
Figure 3-2
CZ
DA
DE
EN
ES
FR
IT
NL
PT
SV
REV B

Publicité

Table des Matières
loading

Table des Matières