Assembling And Adjustments; General; Handle; Cutting Height - McCulloch M46-190 AWREX Manuel D'utilisation

General

IMPORTANT! Prevent unintentional
!
starting by removing the ignition cable
from the spark plug.

Handle

Assembly
Top handle
Place the handlebar's tubular construction in direct
opposite to the lower part of the handlebar. Tighten the
knobs properly.
Use enclosed straps to secure cables to the handle. Do
not overstretch cables when mounting.
Settings
Handle height
• Loosen the lower knobs.
• Adjust the height. Tighten the knobs properly.
62 – English

ASSEMBLING AND ADJUSTMENTS

Cutting height

NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
Move the lever to the back for higher cutting height and to
the front for lower cutting height.

Catcher

• Fit the catcher bag.
• Attach the hooks in the upper edge of the chassis.
• Fit the bagger bottom in the discharge hole.

Mulcher insert

• Raise the discharge guard to mount / dismount the
mulch plug.
Hook the spring in the frame.

Filling with oil

• The oil tank is empty at delivery. Fill the oil slowly. See
instructions under the heading Maintenance. The
engine oil should be changed the first time after 5
hours running time.