After Use - Panasonic MK-F800 Instructions De Fonctionnement

AFTER USE

Cleaning
Pre-wash
The pre-wash enables easier cleaning. It can be used for the Knife Blade and Blender Unit. To pre-wash, simply
follow the steps below.
1 Food Processor
Put the used attachment inside the Bowl, fi ll the Bowl
with water until the attachment is submerged in water
(max. 500 mL). Place the Bowl Lid on top of the Bowl
and turn it clockwise until a 'click' sound is heard.
2
Food Processor: Select the Intermittent mode, push the
Stop/Start Switch and operate for 10 ~ 20 seconds at
level 10.
Blender: Select the Continuous mode, push the Stop/
Start Switch and operate for 10 ~ 20 seconds at level
10.
Wash these items by rinsing them under running water. Use neutral kitchen detergent if necessary. Proceed to
wipe them dry with a clean cloth.
Wash these items by rinsing them under running water, and clean carefully with Brush.
Use neutral kitchen detergent if necessary.
Note:
• These items are extremely sharp and should be handled with extra care while cleaning.
Avoid hitting these items on hard objects during the cleaning process.
• The Mill Container Base must not be washed, use Brush to clean.
GB28
100_160419_MK-F800_Second_EU(UZ50E153).indb


28
Blender
For the Blender Unit, fi ll 500 mL of water into the
Blender Jug and cover with the Blender Lid. Plug-in the
plug into the socket and turn on the Power Switch.
3
Push the Stop/Start Switch to stop the driving operation.
Switch off the Power Switch and unplug from the
socket.
Remove the attachments and proceed for cleaning.




2016/04/19 16:56:52