Troubleshooting - Panasonic MK-F800 Instructions De Fonctionnement

TROUBLESHOOTING

Please check the following points before arranging for service.
Problem
The appliance does not turn on.
None of the Control Panel
Functions can be selected.
The appliance does not start even
the Stop/Start Switch is pressed.
(Error Mode is indicated)
The appliance does not operate
even when the function is started.
(No Error Mode)
The selected function is canceled.
(The Mode Indication L.E.D. starts
blinking).
The appliance suddenly stops
during operation.
GB30
100_160419_MK-F800_Second_EU(UZ50E153).indb
O The plug is loose in the outlet.

¨ Plug in firmly into the outlet.
¨
O The Power Switch has not been
¨ Turn on the Power Switch.
¨
O Gloves may cause insensitivity of the Control Panel.
¨ Select the functions with bare fingers.
¨
O Pressing the function at the wrong position.

¨ Press firmly on the illustration on the Control Panel.
¨
O The appliance is already operating.
¨ The functions cannot be changed when the appliance is
¨
operating. Stop the previous function before selecting a new
one.
O The Bowl, Blender Unit or Dry Mill Unit is not properly locked
onto the Motor Housing.
¨ Ensure that the triangle mark on the attachments are
¨

aligned with the rectangular mark on the Motor Housing as
seen in page GB10.
O The Bowl Lid or Citrus Strainer is not fully locked onto the
Bowl.
¨ Fully secure the Bowl Lid or Citrus Strainer onto the Bowl.
¨
O The ingredients are jammed.

¨ Remove the ingredients carefully and ensure that the
¨
amount used is as stated.
O The appliance was left idle for more than 10 seconds after

selecting the function.
¨ Ensure that action is done after selecting the function within
¨
10 seconds.
O The circuit breaker protection is activated. (Refer to page GB10)
• Too much ingredients were inserted.
¨ Remove the excess ingredients and ensure that the amount
¨
used is as stated.
• Large chunks or hard ingredients were used.
¨ Ensure that the ingredients are cut into the stated sizes.
¨
Do not use hard ingredients such as frozen foods or highly

dense solids.
O The safety lock was triggered. (Refer to page GB10)
• Abnormal vibration during operation may offset the safety
lock engagement.
¨ Ensure that the ingredients used and the amount are as
¨
stated.
¨ Lock the Bowl Lid or Citrus Strainer onto the Bowl firmly,
¨
and ensure that the Bowl, Blender Unit, or Dry Mill Unit is
locked firmly onto the Motor Housing.
30
Cause and Action
2016/04/19 16:56:52