FOOD PROCESSOR
Ingredient Preparations for Salad Drainer
Function
Ingredient
Lettuce
Leaves
Drainer
Cabbage
Operating with Auto Menu
1
After completing the assembly steps, plug-in the plug
into the socket and turn on the Power Switch. The Mode
Indication L.E.D.s will light up and blink.
3
Each Auto Menu has a pre-programmed driving time.
Each lighted bar represents 10 seconds of driving time.
Push the Stop/Start Switch to start the operation.During
operation, the Driving Time L.E.D. will turn off one by
one after every 10 second intervals until the set duration
is completed and 4 beep sounds will be heard. The
Mode Indication L.E.D.s will light up and blink.
Note:
• Maximum working capacity of the Salad Drainer: 200 g or till maximum height of Salad Drainer, whichever
comes first.
• Prohibited ingredients: refer to page GB6.
• Ensure that the ingredients are spread evenly around the Salad Drainer before processing.
• Do not operate the Salad Drainer in any other mode except Drainer mode.
• Always ensure that the Drainer Cover is attached onto the Salad Drainer before operation, otherwise the
ingredients might come out and tear around the Bowl.
• Depending on the amount of ingredients used, there will be significant vibrations present. In that case, hold
down the Bowl Lid with both hands to support it during its operation.
GB22
100_160419_MK-F800_Second_EU(UZ50E153).indb
-SALAD DRAINER-
Max
Mode
Operating Time (approx.)
Single Use
100 g
Initial setting is for 50 g (20 sec)
Auto
200 g
22
20 ~ 60 sec
20 ~ 70 sec
2
Select the Drainer mode. The selected Mode Indication
L.E.D. will light up and a beep sound will be heard. The
Driving Time and Stop/Start Switch Indication L.E.D. will
light up and blink.
4
After the processing is completed, switch off the Power
Switch and unplug from the socket. Remove the Salad
Drainer from the Bowl.
Preparation Method
Cut into 3 ~ 5 cm slices.
Shredded into 1 ~ 3 mm.
2016/04/19
16:56:50