Lighting Instructions - Emerson White-Rodgers 36C03 Instructions D'installation

LIGHTING INSTRUCTIONS

WARNING
!
A. This appliance has a pilot that must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B. BEFORE OPERATING smell all around the appli-
ance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
FOR YOUR SAFETY
"WHAT TO DO IF YOU SMELL GAS"
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a neigh-
bor's phone. Follow the gas supplier's instructions.
1. STOP! Read the precautionary information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. Depress gas control knob slightly and turn clock-
wise to OFF (see fig. 10). If knob is in ON, turn
clockwise to PILOT, then depress knob slightly and
turn clockwise to OFF.
NOTE: Knob cannot be turned from PILOT to OFF
unless knob is depressed slightly. Do not use tools
or excessive force.
5. Wait fifteen (15) minutes to clear out any gas. If you
then smell gas, STOP! Follow B in the precaution-
ary information above. If you don't smell gas, go to
next step.
6. Remove the pilot access panel(s) located under the
gas control unit.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service
is to be performed.
6
FOR YOUR SAFETY READ BEFORE OPERATING
If you do not follow these instructions exactly, a fire or explosion
may result, causing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
Gas Control
Knob
36C Series
TO TURN OFF GAS TO APPLIANCE
Indicator
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or tun by hand, don't try to repair it; call a
qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
7. Find pilot - follow small metal tubes from gas
control.
8. Turn knob on gas control counterclockwise to PILOT.
9. Depress control knob all the way and hold in. Im-
mediately light the pilot with a match. Continue
to hold the control knob down for about one (1)
minute after the pilot is lit. Release knob and it will
pop back up. Pilot should remain lit. If it goes out,
repeat steps 4, 5, 8, and 9.
• If knob does not pop up when released, turn clock-
wise to OFF, stop and immediately call your service
technician or gas supplier.
• If the pilot will not stay lit after several tries, turn
the gas control knob to OFF and call your service
technician or gas supplier.
10. Replace pilot access panel(s).
11. Turn gas control knob counterclockwise to ON.
12. Turn on all electrical power to the appliance.
13. Set thermostat to desired setting.
3. Turn gas control knob clockwise to PILOT.
4. Depress gas control knob slightly and turn clockwise
to OFF. Do not use tools or excessive force.
Gas cock
Figure 9. Gas Cock Knob
P I L OT T H E R M O -
BURNER C O U P L E
Figure 10. Gas Cock Knob
knob