Lighting Instructions; To Turn Off Gas To Appliance - Emerson White-Rodgers 36J22 Instructions D'installation

LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE OPERATING
WARNING
!
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights the
burner. Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the appli-
ance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
FOR YOUR SAFETY
"WHAT TO DO IF YOU SMELL GAS"
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
1. STOP! Read the safety information above on this
page.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device
which automatically lights the burner. Do not try
to light the burner by hand.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
White-Rodgers is a business
of Emerson Electric Co.
The Emerson logo is a
trademark and service mark
of Emerson Electric Co.
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
OPERATING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE

www.white-rodgers.com
www.emersonclimate.com
• Immediately call your gas supplier from a neigh-
bor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to move the gas control
switch. Never use tools. If the switch will not
move by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
5. Remove control access panel.
6. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow "B" in the safety
information above on this page. If you don't smell
gas, go to the next step.
7. Push gas control switch to "ON."
NOTE: Do not force.
8. Replace control access panel.
9. Turn on all electric power to the appliance.
10. Set thermostat to desired setting.
11. If the appliance will not operate, follow the in-
structions "To Turn Off Gas To Appliance" and call
your service technician or gas supplier.
3. Remove control access panel.
4. Push gas control switch to "OFF." Do not force.
5. Replace control access panel.