Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
Operation
2.4 Operation with the
Different Power Systems
2.4.1 Digital
Important:
All of the Märklin central units with
the Motorola transmission format can
be used to run this locomotive. The
full range of functions is only available
with the 6021 Control Unit 6021.
Functions f1 through f4 cannot be
activated if you are using the earlier
Central Unit 6020 or a similar version.
The indicator for direction of travel is
also not present on these units.
The coding switches on the back of
the 6021 Control Unit must be set as
follows for trouble free operation:
Switch:
1
2
3
Setting:
on
on
on
20
Operating the locomotive with the
6021 Control Unit:
Entering the locomotive address.
Turning the speed control knob to
the right to the stop increases the
locomotive's speed. Turning the
speed control knob to the left to the
"0" setting decreases the locomoti-
ve's speed.
Important:
There will be a delay in the locomoti-
ve's reaction to each change in
speed, depending on how you have
set the acceleration/braking delay.
Turning the speed control knob to
the left past the "0" setting: Reverses
the locomotive's direction of travel.
4
off
Important:
On the 6021 Control Unit two arrows
to the right of the address display
indicate the direction of travel for the
locomotive.
Arrow pointing up:
Locomotive runs forward.
Arrow pointing down:
Locomotive runs in reverse.
Pressing the "function" button:
Turns the headlights on.
Pressing the "off" button:
Turns the headlights off.
Pressing button "f2":
Turns the sound effects circuit on
(locomotive operating sounds). Pres-
sing button "f2" again turns the
sound effects off.
Pressing button "f3":
Turns the sound of a horn on. Now
quickly turn this function off by pres-
sing button "f3" again! Otherwise, it
can lead to malfunctions.
Pressing button: "f4":
The Telex couplers front and rear are
turned on. Pressing button "f4" again
turns the Telex couplers off.
Important:
The Telex couplers should not be left
on continuously because there is a
danger of overheating the coupler
solenoids. For that reason they are
protected with a circuit against being
on too long. Please accustom your-
self to turning the Telex couplers on
only as long as necessary.
Publicité
Table des Matières
