Light Emitting Diodes (Led) On Charger - Stihl HSA 66 Notice D'emploi

If the red LEDs glow continuously / flash
A
B
C
D
A 1 LED glows Battery is too
1) 2)
continuously hot
red:
B 4 LEDs flash Malfunction in
red battery
C 3 LEDs glow Power tool is too
continuously hot – allow it to
red: cool down.
D 3 LEDs flash Malfunction in
red power tool
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
2)
During operation: Power tool cuts
out – allow battery to cool down; it
may be necessary to take the
battery out of the power tool for this
purpose.
HSA 66
3)
Electromagnetic interference or
fault. Take the battery out of the
power tool and refit it. Switch on the
machine – if the LEDs continue to
flash, the battery has a malfunction
and must be replaced.
4)
Electromagnetic interference or
fault. Take the battery out of the
machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the power tool –
if the LEDs still flash, the power tool
has a malfunction and must be
checked by a servicing dealer –
STIHL recommends an authorized
STIHL servicing dealer.
1)
/cold
3)
4)
Light Emitting Diodes (LED)
on Charger
1
The LED (1) on the charger may glow
continuously green or flash red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "LEDs on battery".
The green LED on the charger goes off
as soon as the battery is fully charged.
Red flashing light ...
... may indicate the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Malfunction in battery – see also
–
"LEDs on Battery".
Malfunction in charger – have
–
checked by a servicing dealer.
STIHL recommends an authorized
STIHL servicing dealer.
English
9