Emerson PENBROOKE SELECT ECO CF5200AP00 Mode D'emploi page 6

3. Ceiling Fan Assembly
3.4
Install the Clevis Pin and secure with the Hairpin Clip
(Figure 4).
The Clevis Pin must go through the Holes in the Motor
Coupler. It is critical that the Clevis Pin in the Motor
Coupler is properly installed and securely tightened.
Retighten the Phillips Head Screws to secure the
Downrod to the Motor (Figure 4).
WARNING
!
It is critical that the clevis pin and setscrews in the motor
coupler are properly installed and securely tightened.
Failure to verify that the pin and setscrews are properly
installed could result in the fan falling.
3.5
Make sure the Grommet is properly installed in the Coupler
Cover, then slide the Coupler Cover on the Downrod until it
rests on the Motor Housing (Figure 5).
3.6
Place the Ceiling Cover over the Downrod (Figure 6).
Be sure that the Ceiling Cover and the Coupler Cover are
both oriented correctly (Figure 6).
(Continued)
HAIRPIN
CLIP
CLEVIS
PIN
CLEVIS
PIN
RETIGHTEN
PHILLIPS HEAD
SET SCREW (2)
Figure 4
COUPLING COVER
GROMMET
Figure 5
CEILING
COVER
Figure 6
6
MOTOR
COUPLING
HAIRPIN
CLIP
4.5" DOWNROD
COUPLING
COVER
MOTOR
HOUSING
4.5" DOWNROD