Troubleshooting - Emerson PENBROOKE SELECT ECO CF5200AP00 Mode D'emploi

FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE
TROUBLESHOOTING YOUR FAN.
TROUBLE
1. Fan will not start.
1. Loose power line connections to the fan,
or loose switch wire connections in the
switch housing assembly.
2. Fan sounds noisy.
1. Blades not attached to fan.
2. Wire connectors inside switch housing
assembly are rattling.
3. Screws holding blade/flange assembly
to motor hub are loose.
3. Fan wobbles
1. Phillips head set screws in motor coupler
excessively.
are loose.
2. Phillips head set screw in hanger ball/
downrod assembly is loose.
3. Screws securing fan blades to
motor hub are loose.
4. Hanger bracket and/or ceiling outlet
box is not securely fastened.
INSTRUCTION TO THE USER (if device contains a digital device)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC Rules.
In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation
with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The
user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could
void the user's authority to operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

16. Troubleshooting

!
PROBABLE CAUSE
WARNING
1. Check line wire connections to fan and switch
wire connections in the switch housing assembly.
WARNING: Make sure main power is turned OFF.
!
1. Attach blades to fan before operating.
2. Check to make sure wire connectors in switch
housing assembly are not rattling against each other or
against the interior wall of the switch housing assembly.
WARNING: Make sure main power is turned OFF.
!
3. Tighten screws securely.
1. Tighten both Phillips head set screws securely in the
motor coupler.
2. Tighten the Phillips head set screw in the
hanger ball/downrod assembly.
3. Check to be sure screws which attach the fan blades
to the motor hub are tight.
4. Tighten the hanger bracket screws to the outlet box,
and/or secure outlet box.
28
SUGGESTED REMEDY