Erreka TORO KM1800 Guide Rapide page 13

KM1800: Total opening radio code programming (with RSD receiver only)

If a receiver other than RSD is used,
see the corresponding instructions.
1 Connect
the electrical
supply and close the gate by keeping
PUL1 pressed down.
PUL1
2 Select the code in the transmitter.
1 Connect the electrical power supply
and close the gate by keeping PUL1
pressed down.
PUL1
2 Place the DIPs as shown in the
figure (DIP2=ON, DIP1=ON).
DL3 lights up to show programming
mode enabled.
This is carried out in the same way as total travel
programming, with the following differences:
3 Place the DIPs as shown in the
figure (DIP1=ON, DIP4=ON). DL3
lights up to show programming mode
enabled.
power
4 Press the button of the required
channel. DL2
programming is complete.
KM1800: total open/close programming
3 Press ST1 to start opening.
ST1
4 Wait for it to come to a stop at the
end of travel.
5 Press ST1 to start closing.
G160Z
ST1
KM1800: pedestrian open/close programming
5 Place DIP1 and DIP4 in OFF.
DL3 remains off.
6 Disconnect and reconnect the
R160B
electrical power supply.
flashes to show
Programming is carried out in the
same way, using DIP6 instead of DIP4.
6 Wait for it to come to a stop at the
end of travel.
7 Place DIP1 and DIP2 in OFF. DL3
remains off.
• DIP1 and DIP3 are used instead of DIP1 and DIP2
• ST2 is used instead of ST1
• In step 4, stop the gate with ST2
Pedestrian opening radio
code
R160E
R160E
13