Pride Mobility Zolar Manuel De L'utilisateur page 19

For Models 614 and 714:
 Toggle the switch to the left to activate the left throttle
control lever.
 Toggle the switch to the right to activate the right throttle
control lever.
NOTE: Only one throttle control lever will function at a time.
Water Bottle Holder
The water bottle holder is intended to hold a standard size,
plastic water bottle. The holder can be attached to either side
of the scooter using the supplied hardware.
REAR COMPONENTS
The manual freewheel lever, anti-tip wheels (if equipped),
motor/transaxle assembly, and optional safety fl ag brackets
are located on your scooter as shown. See fi gure 8. The main
circuit breaker (reset button) and batteries (not shown) are
also located on the rear component section of your scooter.
WARNING! Before placing your scooter into or
taking it out of freewheel mode, remove the
key from the key switch. Never sit on a scooter
when it is in freewheel mode. Never put a
scooter in freewheel mode on any incline.
Manual Freewheel Lever
Whenever you need or want to push your scooter for short
distances, you can put it in freewheel mode.
1. Remove the key from the key switch.
2. Push forward on the manual freewheel lever to disable the
drive system and the brake system. This will enable you
to push the scooter.
3. Pull back on the manual freewheel lever to reengage the
drive and the brake systems and take your scooter out of
freewheel mode.
WARNING! When your scooter is in freewheel
mode, the braking system is disengaged.
Disengage the drive motors only on a

level surface.
Ensure the key is removed from the key

switch.
Stand to the side of the scooter to engage

or disengage freewheel mode. Never sit
on a scooter to do this.
After you have fi nished pushing your

scooter, always return it to the drive
mode to lock the brakes.
NOTE: If the scooter is placed in freewheel mode (manual
freewheel lever forward) while the key is in the "on"
position, the scooter will not run until the manual freewheel
lever is pushed backward and the key is turned to the "off "
position, then back to the "on" position.
Full-size Scooter Series
I I . Y O U R S C O O T E R
IDENTIFICATION KEY
1. MANUAL FREEWHEEL LEVER
2. MOTOR/TRANSAXLE ASSEMBLY
3. ANTI-TIP WHEELS (if equipped)
4. SAFETY FLAG BRACKETS
2
A
B
C
Figure 8. Rear Components
1
4
3
1
2
3
2 1
19