Disassembly And Assembly - Pride Mobility Zolar Manuel De L'utilisateur

Masquer les pouces Voir aussi pour Zolar:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

V I . D I S A S S E M B LY A N D A S S E M B LY
NOTE: Please check the Scooter Features Table on the inside of the front cover to determine if your scooter
model can be disassembled for transporting or storage purposes.
DISASSEMBLY
You can disassemble the scooter into several pieces: the seat, the rear section, the front section, the batteries, the
basket, and the battery shroud. See fi gure 24. No tools are required to disassemble or assemble your scooter,
but keep in mind that the disassembled sections of the scooter take up more fl oor space than the assembled unit.
Always disassemble or assemble your scooter on a level, dry surface with suffi cient room for you to work and
move around your scooter—about 5 feet (1.5 meters) in all directions. Remember that some scooter components
are heavy and you may need assistance when lifting them.
WARNING! Do not lift weight beyond your physical capability. Ask for assistance when necessary
while disassembling or assembling your Scooter.
WARNING! Do not pick up the seat frame or scooter by the armrests. They are free to pivot, and
you may lose control of the seat if they do so.
IDENTIFICATION
KEY
1.
SEAT
2.
REAR SECTION
3.
FRONT SECTION
4.
BASKET
5.
BATTERY PACK
6.
BATTERY SHROUD
Figure 24. Disassembled Scooter
To disassemble your scooter:
1. Remove the seat by lifting it straight up and off of the scooter. If you encounter resistance when removing the
seat, disengage the seat rotation lever and swivel the seat back and forth while lifting up on the seat.
2. Gently pull the battery shroud forward, then lift up and off of the scooter.
3. Disconnect the battery tie-down strap.
4. Disconnect the front-to-rear harness.
5. Unplug both battery harnesses by depressing the tabs and then pulling each harness straight up. See fi gure 16.
6. Remove the batteries from the battery wells.
NOTE: If spacers are installed to secure the batteries, remove the spacers for safe keeping until the scooter is
reassembled. See fi gure 17.
WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior to
separating the front and rear sections could result in permanent damage to the scooter.
Full-size Scooter Series
1
2
3
4
5
6
37

Publicité

Table des Matières
loading

Table des Matières