Beeper RE004 Manuel D'installation & D'utilisation page 21

INSTALLATION MANUAL
2 • Drilling the bumper
IMPORTANT: Before drilling the bumper, please test the parking sensor with real position to prevent incorrect positioning.
FIG 1 • A drilling tool (hole saw) is provided with the product. Installation can be done on
the injected plastic bumpers, ABS or polyester with a maximum thickness of 4 mm., Metal
bumpers are excluded. Please protect the bumper at the drilling point 6 to 10 cm2 of an
adhesive type of paint to damage the bumper during drilling. Please use a drill with a variable
speed and reversing the direction of rotation. Drilling with the hole saw must be done
meticulously at a slow speed (200 revolutions per minute).
Start with the piercing light counter clockwise at low speed (200 rev / min) of the paint
of the bumper so as not to damage it.
Then drill in the direction of clockwise at low speed (200 rev / min) the plastic wall of the
bumper.
After drilling, we recommend a light sanding of the interior edges to deburr the hole. We also
recommend a thin veil of paint on the edges of the hole and from inside the hole to prevent
sagging of the bumper.
3 • Sensor installation
FIG 2 • First set the sensor with its support without gluing to see and do a range check again
if necessary.
The bracket should be positioned horizontally (see page 20). Clean and degrease perfectly
inside the bumper, the sensor insert the clips into the holder and support assembly & paste
sensor firmly, hold for 10 seconds by pressing evenly on the support.
FIG 1
FIG 2
21