General Diagram - Beeper RE004 Manuel D'installation & D'utilisation

INSTALLATION MANUAL
Painting the sensors
It is advisable to paint the fronts of plane ultrasonic sensors
to obtain a perfect finish.
1. Remove the sensor
holder and the black
silicon circle around sensor.
2. Place the sensors in
the support provided for this purpose.
3. Spend a veil of
spray paint or paint gun.
Do not charge the sensor surface.
4. Depending on the shade used, replace
BLACK silicone or the circle
WHITE / CLEAR.

General diagram

Buzzer: Please place it in the trunk or at the
back seat, in an area protected from splashing
water but allowing the correct propagation of
the sound signal at the front of the vehicle.
18
Main unit : Please place it in the trunk, hidden in a protected area
and water splashes. Electrical connection information on page 8.
Sensors: 4 sensors placed in the
bumper. Installation Information on
page 9 of the sensors.