Beeper RE004 Manuel D'installation & D'utilisation page 17

INSTALLATION MANUAL
Precautions
• The parking sensor is an information system, vehicle safety and people near it is the responsibility of the driver only, the driver must necessarily look if obstacles or people
are closed to his vehicle . Our liability shall be incurred in a collision.
• The sensors ultrasonic parking sensors have physical limits of detection, some obstacles may be invisible or poorly detected:
. objects of low heights <30 cm,
. corners of wall not allowing the reflected signal,
. protruding obstacles such as towbars, bull bars, protection, ... another vehicle,
. objects do not allow a good reflection of the ultrasonic signal: bicycle wheel, fabrics, ...
. human beings will be detected within a meter of the vehicle.
Thank you observe the following before installing the system:
• The system runs on 12V DC (12V DC). Be sure the polarity of each wire.
• Check before installation if all elements of the car are working properly such as ignition & motor starting, lightings and headlights, turn signals, heating, air conditioning,
power door locks, ... Check after installing all these elements work.
• When you connect the system's ground, it is very important that this ground connection is completely open and stable (no leaks).
• Ensure that every wire passing in tight spaces are protected by adhesive tape to avoid excessive twisting and degradation the plastic wire with risk of bad contacts.
• Use a digital multimeter to identify each of the polarities of the wires.
• Do not disconnect the battery if the vehicle has a radio code.
• If the vehicle is equipped with an AIRBAG, do not disconnect the vehicle battery.
• Remove the fuse from ceiling when installing the system to prevent battery drain (door open).
CAN BUS VEHICLES
The system is compatible with BEEPER multiplexed vehicles. All information needed to connect son are on normal polarity (+ or -) which does not pass on information encoded
(multiplexed CANBUS, van or other encoding). You should absolutely not cut or touch a coded wire. IN ALL CASES, THERE IS NO NEED TO CUT A ORIGINAL VEHICLE WIRE,
ONLY YOU MUST MAKE A SPLICE AND RECOVER THE POSITIVE OR NEGATIVE SIGNAL HANDLED THIS THREAD.
17