Switching Off Combi Mode; Switching On The Additional Output - Sentiotec JUST-105D-CO Instructions D'installation Et D'utilisation

Instructions for use for the user
3. Press the humidity symbol a in the middle of the humidity touch wheel b.
► The evaporator switches on.
4. Use the humidity touch wheel b to set the preferred humidity.
► The humidity LED wheel c shows the preset humidity for a few seconds.
► In two-sensor mode with a humidity-temperature sensor, the humidity
LED wheel c then shows the actual humidity. In two-sensor mode with
a bench sensor and in single-sensor mode, it continues showing the
preset humidity.
The evaporator (humidity function B) can only be started when the sauna
heater (temperature function A) is switched on. The maximum humidity
level which can be set depends on the temperature of the sauna. The
higher the sauna temperature, the lower the maximum humidity level
which can be set.

10.7. Switching off combi mode

● Press the temperature symbol d in the middle of the temperature touch
wheel e.
► The sauna heater and the evaporator are switched off.
► The temperature LED wheel f goes out.

10.8. Switching on the additional output

Infrared lamps, or infrared heat plates, for example, can be connected to the
additional output on the sauna control unit.
WARnInG!
Risk of fi re
Flammable objects that are placed on or in front of the infrared lamp
could ignite and cause fi res.
● NEVER place fl ammable objects on or in front of the infrared lamp.
● Make sure that NO fl ammable objects have been placed on or in
front of the infrared lamp before you switch it on.
WORLD OF WELLNESS
p. 39/50
En