Clarke American Sanders 1600DC Manuel De L'utilisateur page 7

revised 9/13
Figure 7
Figure 8
American Sanders Operator's Manual - Sander 1600DC
®
Clarke
HOW TO PREPARE THE MACHINE FOR OPERATION
How to Install the Dust Control Skirt
To install the skirt, follow this procedure:
1. Wrap the skirt around the bumper such that the draw string can be
inserted into the recess of the bumper. See fi gure 7.
2. Orient the brush fastening strap at the rear of the machine to prevent
scratching surfaces.
3. Tighten and tie the string on the skirt into a bow knot so it can later
be untied for removal of the skirt.
4. Twist the ends of the string (see fi gure 7) and insert them into the
recess of the bumper as shown in fi gure 8.
NOTE: The skirt should be stored fl at on the fl oor either on or off
of the machine.
FORM NO. 70408B - 7 -