Clarion NX500 Mode D'emploi Et Manuel D'installation page 58

Installing the Main Unit in TOYOTA Vehicle
Install by using parts attached to the vehicle. (Screws marked
vehicle.)
Center Panel
* 2
( )
*2 Some panel openings are too small for the
unit depending on the vehicle type and
model. In such a case, trim the upper and
lower sides of the panel frame by about
0.5 to 1.5 mm so the unit can be inserted
smoothly.
E x a m p e l
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modification. (Trimming, filing, etc.)
• Removing the Main Unit
When the main unit is to be removed, disassemble it in the reverse of the order in
"INSTALLING THE MAIN UNIT".
58
NX500/NZ500
Main Unit
* 3
Figure 7
Figure 7
*3 If a hook on the installation bracket
interferes with the unit, bend and flatten it
with a nipper or similar tool.
Typical Mounting Brackets
1 Example 2
Affix the screws to the
are attached to the
8- Hexagonal screws
8-Hexagonal screw
(M5x8)
(M5 8)
Mounting bracket
Mounting bracket
(1 pair for the left
(1 pair for the left
and right sides)
and right sides)
E x a m p e l 3
marks.