ProBreeze PB-10 Mode D'emploi page 6

• At 60% humidity, the 60% humidity
indicator light will turn on.
When desired humidity is greater than
actual room humidity, the Humidity Indicator
Light will flash, and the dehumidifier will
enter energy saving standby mode. When
in standby mode, the heater will stop and
the air outlet will stop. The fan will continue
to operate for two minutes to cool the
dehumidifier. After 30 minutes in standby
mode, the fan will switch on for five minutes
to check the humidity of the room. If the
room humidity has not increased by more
than 5% of desired humidity, the dehumidifier
will return to standby mode. Once the
room humidity increases by more than 5%
of desired humidity, the dehumidifier will
automatically restart and return to operation.
Current Room Humidity % RH is displayed
by the Room Humidity Indicator Lights.
E.g. if the room humidity is 40% RH one
light will illuminate next to 40%. If the room
humidity is 45% RH two lights will illuminate,
one next to 40% and one next to 50%.
CONNECTING THE WATER HOSE
FOR CONTINUOUS DRAINING
― ―
For long-term use, it is recommended to
connect a hose for continuous drainage.
To attach the hose:
1. Use a screwdriver or similar tool to
remove the plastic covering from the
continuous drainage hole at the back of
the dehumidifier.
2. Check that the water tank is securely in
position.
3. Insert the hose into the water hose
connector and check it is connected
properly. (12mm)
5 | English
REMOVING AND EMPTYING THE
WATER TANK
― ―
When the water tank is full three beeps will
sound; the Water Tank Full Indicator Light will
continuously flash and the dehumidifier will
pause operation to prevent the water tank
from overflowing. To remove and empty the
water tank:
1. Turn off the dehumidifier, wait two
minutes for the fan to stop, and unplug it
from the wall socket.
2. Gently pull the water tank out from the
front of the dehumidifier.
3. Use handle to empty the water tank.
4. Once empty, slot the tank back in
carefully.
DO NOT remove the float from the top of the
water tank as this may cause damage and
prevent the dehumidifier from functioning as
intended.
NOTE: If the water tank is full or not inserted
correctly, the Water Tank Full Indicator Light
will flash and the appliance will turn off.