GYS STARTPACK PRO 12.24 XL Notice Originale page 14

Translation of the original instructions
The GYSFLASH 6.12 XL and the power supply cable can be fitted on the STARTPACK PRO 12.24 XL or kept sepa-
2
rated (screws included).
!
When using the STARTPACK PRO 12.24 XL outdoors, the power supply cable is not weather proof .
M4x20
USE IN STARTER MODE
VERIFICATION OF THE INTERNAL BATTERIES STATE OF HEALTH
START
14
STARTPACK PRO 12.24 XL
x4 -
• Disconnect the power supply cable.
• Check the internal batteries by pressing the power button for 10 seconds.
• The state of the internal batteries is displayed for 10 secs.
• The batteries are fully charged when the green led switches on.
- Green led : The start is possible.
- Orange led : The start is possible but not recommended. Perform a charge.
- Red led : The start is impossible. Perform a charge.
• Plug the selector on 12V or 24V depending on the vehicle to start.
• Connect the red clamp to the positive terminal (+) and the black clamp to the
negative terminal (-) of the battery.
In case of polarity inversion, the STARTPACK PRO 12.24 XL will signal it by :
buzzer + red LED light on.
• Switch the STARTPACK PRO 12.24 XL on by pressing the power button for 3 secs.
x4
EN
EN