Table des Matières
Publicité
Installation Instructions for Escutcheon Trim
1
Install chassis.
Route chassis connector through the upper 5/8" hole on the interior side
of the door, and pull through the slack as you slide chassis into mortise.
You may use needle-nose pliers to gently pull the cable through the hole.
Hole
INTERIOR
2
Install lever spindle on the exterior side of the door.
Install spring on lever spindle.
6
Continue for installation instructions for
your lock with escutcheon (Addison)
trim.
For sectional
(Greenwich) trim
instructions go
to page 3.
NOTICE
Start screws but
don't fully tighten
until Step 9!
EXTERIOR
3
Install mounting posts and spring cage.
Arrows on the spring cage points in direction of lever down rotation. Use
pliers to carefully install mounting posts to avoid damage.
4
Install the outside trim and route wire all the way through
the hole to the interior side of door.
Route wire from
outside trim above
wire from the chassis.
NOTICE
Arrows in direction
of lever down
rotation.
Publicité
Table des Matières
