6
Partly install the key cylinder.
Turn key cylinder into the chassis. Tighten just enough to secure outside
trim. Insert key, then pull out one notch to aid with turning.
7
Install inside spindle, spring cage, and mounting plate.
Arrow on the mounting plate faces in direction of lever down rotation.
NOTICE
Arrows in direction of
lever down rotation.
8
Install the inside rose and lever.
4
NOTICE
Do not tighten more than
six full turns! Tighten
fully at step 12!
INTERIOR
*included in box
9
Connect the cables to the inside assembly.
There are two cables that need to be connected.
10
Deadbolt (LEMD) Only: Align driver bar into the
chassis.
Thumbturn should be vertical when deadbolt is retracted.
11
Install the inside assembly.
Cable slack
should be folded
downward.
Actual Size