Table des Matières
Publicité
Installation Instructions for Sectional Trim
1
Install chassis.
Route chassis connector through the upper 5/8" hole on the interior side
of the door, and pull through the slack as you slide chassis into mortise.
You may use needle-nose pliers to gently pull the cable through the hole.
Hole
INTERIOR
2
Install lever spindle on the exterior side of the door.
Install spring on lever spindle.
Continue for installation instructions
for your lock with sectional trim
(Greenwich).
For escutcheon
(Addison) trim
instructions go
to page 6.
CAUTION
Start screws but
don't fully tighten
until Step 12!
EXTERIOR
3
Install spring cage into lever.
Use pliers carefully to install mounting posts to avoid damage.
4
Install outside lever.
5
Install the outside trim and route wire all the way through
the hole to the interior side of door.
Route wire from
outside trim above
wire from the chassis.
IMPORTANT
Arrows in direction of
lever down rotation.
Fully tighten mounting
posts on screws.
EXTERIOR
EXTERIOR
3
Publicité
Table des Matières
