Technical Data; Warning Information - Truma Mover S Mode D'emploi

Commissioning the Mover
Ensure the battery used to operate the Mover is fully charged.
Park the caravan outside on an open, level surface and apply
the handbrake. Ensure that the rollers are disengaged from
the road tyres and the corner steadies are raised.
Connect battery terminals to battery, check that all cables are
secure and not hot or indicating signs of short circuits, etc.
Move slide switch on remote hand set to the "On" I position.
This switches the remote hand set on – green LED flashes for
5 seconds in combination with the acoustic alarm until the
control unit is ready for operation. If LED does not illuminate,
check polarity and condition of batteries in remote hand set.
The remote hand set switches itself off after about 2 minutes
if no buttons are pressed.
Check whether both drive motors are stationary. With the re-
mote hand set switched on, and no more than 2 m away from
the control unit, press the "Forwards" button. Both drive mo-
tors must now move in the forwards direction.
Move slide switch on remote control to the "Off"
to switch the remote control and therefore the Mover off.
Move drive rollers against the tyres using the provided swivel-
ling lever. Turn the swivelling lever until it mechanically engag-
es and cannot be turned any further without using excessive
force (end position approximately horizontal).
Ensure that there no obstacles around the caravan, release the
handbrake and switch the remote control on. Now check all
functions several times according the operating instructions.
Move slide switch on remote hand set to the "Off"
to switch the remote hand set and the Mover off. Apply cara-
van brake. Release drive rollers using swivelling lever and
re-check distance between roller and tyre. Adjust if necessary.
The distance between the swivelled-out drive rollers and
the tyres is 20 mm.

Warning information

The yellow sticker with the warning information, which is
enclosed with the appliance, must be affixed by the installer
or vehicle owner to a place in the vehicle where it is clearly
visible to all users (e.g. on the wardrobe door)! Ask Truma to
send you a sticker, if necessary.
20

Technical data

Designation:
Area of operation:
Operational voltage:
Current consumption:
Stand by consumption:
Remote hand set
frequency:
Speed:
Weights:
Right to effect technical modifications reserved!
o
position
o
position
Mover S
Single axle caravans with a
total weight up to 1800 kg
12 V DC
Average approx. 20 A
Maximum 120 A
< 20 mA
Class 1, 868 MHz
Approx. 16 cm per second (de-
pending on weight and incline)
Approx. 35 kg (including cross
actuation device)