Publicité
C
Note: This option is
displayed only after ‘Set
entry points’ is done (refer
to 7.4.1). You can set
specific entry point or to
set ‘Cyclic’. which means
that the mower uses all
entry points set cyclic
mode.
GO
Manual
User Option
GO
Settings
Press GO
GO
Docking option
Press GO
GO
Weekly program
Press GO
GO
Set program
Press GO
GO
M T W T F S S
Press GO
GO
Entry point: Cyclic
Confirm
GO
Work time: 2:00
Confirm
GO
Depart 00:00
Confirm
GO
Depart 12:30
Next digit
GO
Mode Edge + Mow
Confirm
GO
M T W T F S S
Press GO
GO
Scroll up or down until
“Docking option” is displayed
EN
and press ‘GO’
Scroll to program the day
of mowing and press ‘GO’
Scroll to set the entry point for
the programmed day and
press ‘GO’
Scroll to set the work time for
the programmed day and
press ‘GO’
Scroll to set the depart time -
and press GO after setting
each digit.
Scroll to the required operation
mode and press ‘GO’
(“Edge + mow” or “Mow” only.
To clear an active day: “none”)
Scroll to the next day you
want to set and press ‘GO’
Publicité
