Sleep Timer; Setting The Alarm - SilverCrest SWDR 500 A1 Manuel D'utilisation Et Informations Sur Les Services

SilverCrest SWDR 500 A1

SLEEP timer

The SLEEP timer function lets you set a countdown time between 10 and 90
minutes. After this time, the multi-band tuner (A) switches off automatically. This
setting can be adjusted in 10-minutes steps. The procedure is as follows:
 Press the "POWER/SLEEP" button (8) to power the device off.
 Keep the "POWER/SLEEP" button (8) pressed for approx. one second until
the display (6) reads "90" (for 90 minutes). The "SLEEP" icon (32) flashes.
 Press the "POWER/SLEEP" button (8) as many times as necessary to display
the desired time in minutes (e.g. 40). Each press of the "POWER/SLEEP"
button (8) reduces the number of minutes before power off by 10 minutes.
 Now the multi-band tuner (A) switches on and automatically off after the set
countdown time (e.g. 40) has elapsed.
 While the sleep timer is enabled, the "SLEEP" icon (32) is shown on the
display (6).
 While the sleep timer is enabled, it is still possible to select a different
frequency band, to start a station search, to recall a stored station and to set
the volume.
 You can cancel the enabled sleep timer by switching the device off.

Setting the alarm

You can set up to two alarm times (AL1 and AL2). Verify that the clock displays
the correct time. The alarm time can only be set while the device is powered
off. If it is powered on, press the "POWER/SLEEP" button (8) to power the
device off.
In the following we describe the setting for AL1. You can program AL2 in the
same way. If during the setting procedure no button is pressed for approx. 8
seconds, the settings are applied and the setting mode is quit.
 Press the "M-/AL1" button (14) for approx. 1 second. The hours flash on the
display (6).
74 - English