Manual Station Search; Manually Tuning A Station - SilverCrest SWDR 500 A1 Manuel D'utilisation Et Informations Sur Les Services

 Press the "BAND" button (7) to select the desired frequency band.
 Keep the "SET/STORE" button (9) pressed for approx. 1 second to launch
the automatic station search. The automatic station search always starts at
the lowest frequency.
 The multi-band tuner (A) will scan the entire frequency band for strong radio
stations.
 The 100 first found stations are directly saved on the presets P001 to P100.
After all 100 presets have been filled, the station search continues to the end of
the frequency band but no more stations will be saved. After the scan is
finished, the station of preset P001 will be tuned-in.
Please note that any station presets already used will be
overwritten.

Manual station search

 Power the device on.
 Press the "BAND" button (7) to select the desired frequency band.
The short wave band "SW" is divided into 9 different frequency sub-bands
"SW1" to "SW9" (see the "Technical specifications" chapter). To select the
different short wave bands, start pressing the "MODE" button (15) twice. The
upper part of display reads "SW << >>". Press the "TUNE-" (13) or "TUNE+"
(11) button to select the desired SW band. Press the "MODE" button (15)
again to start searching for any stations.
 Keep the "TUNE-" (13) or "TUNE+" (11) button pressed for approx. one
second to launch the station search down or upwards. The search will stop
when the next station has been found and its frequency is shown on the
display (6).

Manually tuning a station

Besides the automatic station search, you can also tune in a station manually.
This allows you to also tune-in any weaker stations. Proceed as follows:
SilverCrest SWDR 500 A1
English - 71