Nap Timer - SilverCrest SWDR 500 A1 Manuel D'utilisation Et Informations Sur Les Services

SilverCrest SWDR 500 A1
 Press the "TUNE-" (13) or " TUNE+" (11) button to program more SDAs in
the same way.
The enabled SDAs will sound every year. If the current date matches the set
SDA alarm date, the buzzer will sound for approx. 10 minutes hourly between
08:00 h and 23:00 h. The current radio mode is not interrupted by the SDA.
The alarm will sound only after the user has stopped radio mode and the
minutes digit has increased by "1".
Press any button to disable the alarm sound.

NAP timer

You can set a nap timer (with alarm buzzer only) for a one-time power on
event. There are 6 preset times, use the "TUNE-" (13) or "TUNE+" (11) button
to select one. The default settings of the 6 timers are different and are 10, 15,
20, 25, 30 and 35 minutes.
 While the device is powered off, press the "MODE" button (15) twice. The
NAP timer icon (42), the timer number and the preset power-on time in
minutes appear on the display (6).
 Press the "TUNE-" (13) or " TUNE+" (11) button multiple times to toggle
between the preset times.
 Press the "VOL-" (12) and "VOL +" (4) buttons to set these times from 1 to 39
minutes as required.
 Press the "SET/STORE" button (9) briefly to launch the timer.
 The countdown appears on the display (6). After the timer is finished, an
alarm will sound until you disable it.
Press any button to disable the nap timer alarm buzzer.
 Press the "SET/STORE" button (9) briefly to cancel the enabled NAP timer
before the countdown ends. The remaining time of the previously set timer is
shown on the display. Press the "SET/STORE" button (9) briefly again to
relaunch the timer with the remaining time.
 While the timer is running, you can change its value by pressing the "VOL-"
(12) or "VOL+" (4) buttons.
68 - English