Recalling A Saved Station; Stereo Output - SilverCrest SWDR 500 A1 Manuel D'utilisation Et Informations Sur Les Services

 Press "M-/AL1" (14) or "M+/AL2" (10) to select the desired preset where
you want to store the station.
 Press the "SET/STORE" button (9) to finish saving.
Please note that any station presets already used will be
overwritten.

Recalling a saved station

 To tune in a previously stored station, press "M-/AL1" (14) or "M+/AL2"
(10) to select the preset where the desired station has been saved.
Please note:
On delivery, the presets are empty. When selecting an empty
preset, the lowest frequency of the selected band is tuned in.
Once a station has been saved on a preset, its frequency is stored
until it is overwritten by a new frequency.
When no power is supplied to the multi-band tuner, the clock is
erased but the stored stations are preserved.

Stereo output

A stereo sound output is only possible while the earphones are connected. In
this case, the display (6) will show the "ST" (30) icon.
However, the stereo signal may be weak or noisy in some cases. In "AUTO-ST"
mode the multi-band tuner will toggle between "MONO" and "STEREO"
depending on the signal quality.
However, you can always use the "MONO" setting if you want. To do so, in
radio mode, press the "MODE" button (15) twice and then use the "TUNE-"
(13) or "TUNE+" (11) button to select between the "MONO" and "AUTO-ST"
settings. The setting made here will prevail until you change it again.
SilverCrest SWDR 500 A1
English - 73