Abicor Binzel ABIROB A Mode D'emploi page 36

Masquer les pouces Voir aussi pour ABIROB A:

Table des Matières

Les langues disponibles

6 Putting into operation

6.3 Attaching the machine-side connector

6.4 Connecting the control lead

a = green, b = white, c = brown, d = yellow (insulated), e = grey (insulated), f = blue (insulated),

g = pink (insulated), h = black, i = purple, j = red (insulated)

Fig. 6

Connecting the control lead

EN - 14

 Fig. 5 Setting up the cable assembly on page EN-13

Check once again whether the wire guide has been fitted correctly.

1 Join the central connector (4) and the central socket at the wire feeder and

secure them with the connection nut (6).

2 Fasten the air-blast hose (5) to the air-blast and injection unit or the air-blast

valve. Seal the connector gas tight if the 'air blast' option is not used.

 Fig. 5 Setting up the cable assembly on page EN-13

The control lead (3) is open on the machine side. The customer must connect

a suitable plug. If all data are provided, the device can also be delivered ready

for connection. Otherwise, choose a compatible plug for your power source

and solder it to the corresponding leads according to the terminal diagram.

ABIROB

Table des Matières